|
1)For Dirt Location
Attach
SoiI Stabilizer to the Anchor‑Mate approximately 6"from
the top with (2) Corner Bolts. Drive Anchor‑Mate into the
ground until approximately 3"remain above ground. Be sure
to align anchor with traffic flow.
2)For Concrete Location
Dig
or auger a hole 32"deep and with a minimum of 8"in diameter,
Place the Anchor‑Mate into the hole with 3" above grade.
Fill hole with concrete. Be sure to cover top opening and holes
in the anchor to prevent concrete from entering. After the concrete
is cured proceed with next step,
3)Install
Slip‑Mate assembly into the Anchor‑Mate with the 6"stub
down and secure with (2) 3/8" x 3" bolts, (As shown)
4)Place
post with sign attached onto the top stub of Slip‑Mate secure
with (3) 3/8" x 3" bolts, (As shown)
Anchor-Mate
with Soil Stabilizer Assembly
Slip-Mate Assembly
|
